HiFiCafe.SG

A new 2 channel centric forum has just been established for local audiophiles. Hopefully this site is able to gain some traction. Singapore has not seen an active audio forum since the days of Echoloft.

Click on this link to visit.  

Comments

Post a Comment

Popular posts from this blog

Plixir Signature Interconnect

Image
Introduction Sound Affairs has expanded it's Plixir line to linclude high-end interconnects and power cables. You may want to have a look at my earlier post on the Plixir Elementa power cord. I took a look recently at the Signature Interconnect, which sits above the entry-level model, Elementa. Description The Plixir Signature Interconnect is finished in a pale blue jacket and is available in both RCA and XLR versions. The cable utilises Ohno Continuous Cast (OCC) copper conductors arranged in a star quad geometry, and is shielded. The cable is marked for signal direction. While I did not try to use the cable the "wrong" way around, the braided shield is tied at the source end only and should sound different hooked up both ways. The RCA version I had on hand was terminated with DH Labs RCA plugs. The cables are quite flexible and unable to suspend light components in the air, unlike some of it's competitors. The plugs lack jaws of death required to rip out your RCA s
Read more

Acrolink 7N-PC4030 Anniversario

Image
Introduction Here is a special edition of the ever popular Acrolink 7N-4030 power cable. This has been one of my favourite cables over the years. You may want to have a look at my earlier posts on the 6N-4030 and the 7N-4030II . Description The Anniversario is available both in factory terminated version (the Anniversario CB) and off-the-reel. A smaller gauge version is also available in the form of the 7N-PC4020 Anniversario. The Anniversario continues to use 7N DUCC copper conductors. However,  this model uses larger diameter copper strands but with less strand count compared to the it's predecessor ( 50 strands of 0.37 mm diameter copper  vs. 100 strands of 0.26 mm diameter). The outer copper foil shield gets a drain wire which permits you to ground the shield if desired.  The black jacket of the 7N-4030II had a rubbery feel to it, and the very fragile wording reminded me of some of my NOS vacuum tubes - a touch and that was the end of the print ! I much prefer the new jacket t
Read more

Acrolink Mexcel 7N-PC7500 and 7N-PC9500 power cords

Image
I was at the local dealer's showroom looking at a new shipment of power cords from Acrolink of Japan. The dealer had a large smile on his face as his enthused over the virtues of the new Mexcel range. I cautiously asked about the pricing, and the dealer nonchalantly rattled of some mind boggling numbers. Either audiophiles have become very rich over the years, or the dealer had serious mis-estimates about the state of affairs of my bank account. He invited me to listen to the 7N-PC7500 which was currently being run-in, and had on hand the much older model, the 7N-PC 7100. He disconnected the 7500 and hooked up the 7100 for a quick listen - smart move. Mentally, I was hoping that both cables would sound the same. I already had the PC7100 at home, and spending even more money was not at the top of my wish list. I listened to a few familiar tracks through the wonderful setup for the day, the beautiful Vivid Giya G3s powered by amplification from Technical Brain, and fronted by a digit
Read more